A burn quality test in my NU drive

PIE very low with a peak of 7 and a low average of 3 they don't come much better,. Jitter peaked at 12.9% with an average of 11.2% and a smooth pattern this is another good result PIF errors are virtually non existent

So here we have an example of a very good burn and have to put this result with the best of the best

Speed test in the Toshiba drive

This scan shows a perfect graph. What more can I say?

Burn quality as tested in the NU drive

Just when I said they don't come much better we have another one from the NEC drive PIE peak of 6 and an average of 2. Jitter peak 12.5% and average of 11%. With probably slightly more PIF errors but immeasurable being so low

Speed test in the Toshiba drive

This scan shows a perfect graph again What more can I say?

Burn quality as tested in the NU drive

Good PIE graph with a peak of 32 and average of 14. Jitter 14.5% peak 12.8% average, and negligible PIF errors

Good results here but not in the same class as the Pioneer, NEC, Benq & Plextor

Speed test in the Toshiba drive

This scan shows a perfect graph that goes off the scale in my Toshiba. This is a typical result from the Liteon clone drives when they have burnt DVD+R at DVD-ROM book format

Burn quality as tested in the NU drive

Looks like I have to eat my words. What can I say the performance here outstrips the competition when I did not think a scan like this was possible!!
PIE peaks at 4 and averages 1. Jitter peak 11.2% average 10.1%. PIF errors ZERO

I am SPEECHLESS at this result especially when it comes from a Bulkpaq disc

Speed test in the Toshiba drive

This scan shows a perfect graph. and there is nothing more to say

Burn quality as tested in the NU drive

PIE peaks at 7 & averages 2, Jitter peak 12.2% average 10.8%. PIF negligible with a peak of 4. This PIF peak at the 3.5gig point should be ignored as there is a scratch on the disc at this point but it did not affect playback

So here again we have a very good burn

Speed test in the Toshiba drive

This scan shows an almost perfect graph with just one minor blip and upon examining the disc surface there is a scratch at about that point which I put down to bad handling and this could be my fault.

Burn quality as tested in the NU drive

PIF is fairly stable around the 40 mark up to about 3gig when it starts to rise and reaches a peak of 250. Jitter is on the high side peaking at 15.9% with an average of 13.7%. A few more PIF errors but not excessive peaking at 8 at the edge of the disc

The PIF rise towards the outer edge is not good and should be a lot lower as is shown by the other burns but saying this the playback is OK throughout the entire disc.

Speed test in the Toshiba drive

Again no problems here at reading the disc

Burn quality as tested in the NU drive

PIE peaks at 104, averages 32 peaking towards the outer rim not unlike its Liteon counterpart but not as severe. Jitter peak 15.5% average 13.2% is a bit on the high side and only a few PIF errors

This is an average burn that plays well but could be a lot better

Speed test in the Toshiba drive

This scan shows a perfect graph