A burn quality test in my BenQ drive

PI starting below 10 and peaking at a maximum of just over 20 with no sharp peaks, a good scan with this one

Jitter % starting well below 10% and remaining so for most of the scan with an average of 8.7 very good

PIF although low is a little disappointing peaking at a mere 13 and a minor cluster in the higher speed area

The time taken to complete this burn was 7m15sec

Speed test in the Toshiba drive

This scan shows an almost perfect graph again What more can I say?

Burn quality as tested in the BenQ drive

PI again stating at about 10 rising to just over 20 at the end of the scan without any excessive peaks. This graph is very similar to the Pioneer scan but marginally higher A good scan

Jitter averages below 10% but does show an amount of fluctuation but still well within acceptable limits

PIF is also comparable with the Pioneer but marginally higher with a peak of 25 causing the rescaling up to40 max

The time taken to complete this burn was 6m40sec

Speed test in the Toshiba drive

Some minor blips in the read speed but the speed does not drop bellow 8 and there are only a few with minimal problems at the outer edge. I cannot see this causing any problems

Burn quality as tested in the BenQ drive

PI starting at just under 40 dropping down to 10 and then a slight rise to 20 at the end of the scan. This is the best graph I have obtained with recent CMCMAG media and this drive and although it is the highest of these three it is still a very good result

Jitter remains constant at just below 10% averaging below 10%

Although there are a lot of PIF errors the are all well below 10 and as such should not affect playback or readability

The time taken to complete this burn was 7m28sec

Speed test in the Toshiba drive

As good as it gets