SAMSUNG
TSSTcorp_CD-DVDW_SH-S182D

Category SH-S182D(TS-H652D)
DVD Writer
DISC Usable Discs
DVD : DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM,
DVD-Video, DVD+R (Dual), DVD-R (Dual),DVD-RAM
CD : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G)
CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD
CD-I, CD-I Bridge (Photo-CD, Video-CD),
Multisession CD (Photo-CD, CD-EXTRA, Portforio)
Disc Diameter 4.72 Inch or 3.15 Inch (120mm or 80mm)
Interface Support Interface Port ATA/ATAPI (E-IDE)
PIO mode PIO Mode 4: 16.6MB/sec
DMA mode Ultra DMA Mode 2: 33.3MB/sec
ACCESS TIME (Random) CD-ROM 110ms (Random)
DVD-ROM 130ms (Random)
Data Transfer Speed
(Max)
Media Type
Write
Read
DVD+R
CAV 18X (24.3MB/sec)
CAV 12X (16.2MB/sec)
DVD+RW
Z-CLV 8X (10.8MB/sec)
CAV 8X (10.8MB/sec)
DVD+R DUAL
Z-CLV 8X (10.8MB/sec)
CAV 8X (10.8MB/sec)
DVD-R DUAL
Z-CLV 8X (10.8MB/sec)
CAV 8X (10.8MB/sec)
DVD-R
CAV 18X (24.3MB/sec)
CAV 12X (16.2MB/sec)
DVD-RW
Z-CLV 6X (8.1MB/sec)
CAV 8X (10.8MB/sec)
DVD-ROM(Single)
-
CAV 16X (21.6MB/sec)
DVD-ROM(Dual)
-
CAV 8X (10.8MB/sec)
DVD+RAM CAV 12X(16.2MB/sec) CAV 12X(16.2MB/sec)
CD-ROM
-
CAV 48X(7.2MB/s)
CD-R
PCAV 48X (7.2MB/sec)
CAV 40X (6.0MB/sec)
US-RW
Z-CLV 32X (4.8MB/sec)
CAV 40X (6.0MB/sec)
HS-RW
CLV 10X (1.5MB/sec)
CAV 40X (6.0MB/sec)
CD-RW
CLV 4X (0.6MB/sec)
CAV 40X (6.0MB/sec)
Buffer Memory 2MB
Drive Installation Horizontal / Vertical
Operating Environment Temperature 41°F ~ 122°F (5°C ~ 45°C)
Humidity 5%~80%(RH)
Size(Width x Height x Length) 5.83 X1.65 X 6.69 Inch (148.2 X 42 X 170mm)
Weight 750g


  Note
  Does not support DVD-R for Authoring.
  Cannot playback or record on both sides of a two-sided disc simultaneously.
  The read/write capacity of the supported discs depends on the condition of the disc
  and the recording format of the drive. Therefore, the read/write quality may not be perfect.
  Severe vibration or external impact may decrease the quality of printed images.
  Please firmly place the product onto the PC before use.
  In case of disk identification error message, thoroughly clean the surface of the disk
  where the label is presented and then start printing.
  The quality of the printed image cannot be ensured if printing an image on the area
  which is already used for printing.
  For more information on the writing and duplicating the Lightscribe disk label,
  install Nero software and refer to the HELP section.
 
  Fcc information to the user
  This equipment has been tested and found to comply with the limits for a class B digital device. pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. this equipment generates.
Uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions. may cause harmful interference to radio communications However. there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception.
Wiich can be determined by tuming the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures.
  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  Consult the dealer or experienced radio TV technician for help.
  CAUTION
Change or modifications not expressly approded by the manufacturer responslble for comliance could void the user's authority to operate the equipment.
  Laser Standand
IEC 60825-1 : 1993 + A1 : 1997 + A2 : 2001